When operating a CNC cutting machine, it is necessary to be familiar with the equipment's properties, operating methods, and to open the operating notes. The following is
1. The tools used for selection and service should be standardized according to the parameters allowed by the CNC milling machine, and any particularly heavy or worn-out tools should be replaced immediately to avoid discounts on equipment and raw materials.
2. Test whether the movable components of the testing equipment are in normal working condition, and whether the workbench is in an offside or over pole state.
3. Check whether the electrical components are in good condition and whether the wiring falls off.
4. Before the initial operation of the CNC milling machine, it is necessary to preheat it and check if the lubrication system is functioning properly. In case it has not been turned on for a long time, manual methods should be used to supply power to each part for lubrication; Check if the voltage, pulse pressure, and intraocular pressure are in line with the desired outcome.
5. Mobilize cutting tools, never forget the tools used in the equipment.
6. Is the basic hole of large-sized shaft components age appropriate? If the main hole is too small, it is easy to encounter difficulties during work.
7. Before starting the CNC milling machine, it is necessary to close the protective door and reflect on the state of the chuck clamping labor.
8. After the cutting tool is installed, two trial cuts should be carried out.